Gilbarco Passport v22.02 (22020106) software for Phillips 66®, 76® and Conoco® branded stations is now available.
V22.02 Improvements:
- PCI-SSF Certification
- Verifone M400 PIN pad support
- Support for PPG over $9.99
- Bug Fixes
Software/PCI Compliance/EMV
Phillips 66 recommends that EPOS software be maintained to the most current update or at minimum must run an approved version listed on Gateway and Bizlink. This v22.02 software is certified to the new PCI SSF standard and can be used by the sites to support their PCI compliance requirements. Software updates may require additional hardware updates and/or a technician visit to complete the upgrade and configurations. Completing hardware upgrades for Outside EMV remain as a marketer/site choice, however, the EMV liability for all chargebacks did shift to all sites on April 16, 2021.
As a reminder, Gilbarco v21.03+ software supports WEX EMV and Contactless EMV. Sites still running older software are susceptible to the EMV liability shift for both of these chargeback types.
A determination will be made in the near future for older versions to be considered “expired software”, and a date will be set at that time when sites must be upgraded before being subject to non-compliance fees. This information will be published on Gateway, Bizlink, and in the Weekly Fill-up.
Installation
Sites with Insite360 may be able to download the new software to their system. Certain pump firmware updates may be required before software can be upgraded. Sites should contact Gilbarco for more information or contact your local Gilbarco installer and/or local dispenser technician to schedule an upgrade date, make billing and timing arrangements and find out more about upgrade requirements.
MNSP
As with previous versions, a Managed Network Service Provider (MNSP) device must be installed prior to the software update. The MNSP device is a Gilbarco requirement and is available from Hughes or Sagenet at a cost of $399 for the device and $9.99 a month added to your monthly LinkSafe invoice.
To order or find out more information about the MNSP, contact your LinkSafe provider.
- Sagenet at 866-488-7687
- Hughes at 888-716-6850
