EPC version is 3.2.001.11, and RPOS version 2021.13.5 improvements:
- Integrated EBT support through Phillips 66 network
- Contactless EMV at the pump
- Verifone M400 support
- Wayne T7 and Anthem support (iXPay2)
- Optic 5T support
- Gilbarco Flexpay 2 support – Note: NCR End of Certification Support for Flexpay 2 is Dec. 31, 2022.
- MC Fleet pump prompting fixes
- Synchrony card prompting fixes
- Loyalty paper receipt fix
Installation
Phillips 66 recommends that EPOS software be installed as per manufacturer deployment guide, and be maintained to the most current update, or at minimum must run an approved version listed on Gateway/Bizlink. Software updates may require additional hardware updates and/or a technician visit to complete the upgrade and configurations. Completing hardware upgrades for Outside EMV remain as a marketer/site choice, however, the EMV liability for all chargebacks did shift to all sites on April 16, 2021.
A determination will be made in the near future for older versions to be considered “expired software”, and a date will be set at that time when sites must be upgraded before being subject to non-compliance fees. This information will be published on Gateway and in the Weekly Fill-up.
Sites should contact their NCR support partner for more information and to schedule an upgrade date.
MNSP
As with previous versions, a Managed Network Service Provider (MNSP) device must be installed prior to the software update. The MNSP device is a NCR requirement and is available from Hughes or Sagenet at a cost of $399 for the device and $9.99 a month added to your monthly LinkSafe invoice.
To order or find out more information about the MNSP, contact your LinkSafe provider.
- Sagenet at 866-488-7687
- Hughes at 888-716-6850
